Towing winch in Decks machinery.

Seperator



Hydraulical clutch | Series 021

Hydraulical clutch | Series 021

Based on our friction linings, which have been tried and trusted for many years in the marine sector, clutches in this series reconcile high torque and thermal absorption rates as well as a favorable outer diameter. A high shaft diameter can also be used.

 

Due to their broad power spectrum, smaller sizes can be achieved with corresponding weight and cost benefits, especially in higher torque ranges. The optimized outer diameter makes shorter distances between axles possible, and in this way offers clear savings potential in the gearbox.

 

The hydraulic multi-plate clutch impresses with its comprehensive service friendliness. The plate pack, which is wear-free under the specified conditions, can be accessed from either side depending on the model, and ensures an easy, safe, and swift replacement of the plate pack. The special design also ensures that other components cannot fall out during replacement.

 

The Ortlinghaus muti-plate clutches safely accelerate even large propellers and generators. This optimal further development of our tried-and-tested technology sets today’s industry standards.

 

Torque:
10,000 - 90,000 Nm
Rotations per minute:
9,800 - 350 min-1
Outside diameter:
90 - 1,200 mm
Bore diameter:
35 - 500 mm
Length:
64 - 755 mm

Seperator


Slipping clutch | Series 600

Slipping clutch | Series 600

Ortlinghaus slipping clutches are always used when external peak loads need to be absorbed and smoothed safely. They provide protection from breakage, especially for anchor winches in the marine sector. As the release torque can be set, torque is also transferred during slipping so that no uncontrolled torque transmission takes place. A reset is not required either.

Our safety clutches have proven their worth in decades of the most demanding marine use and undergo constant further development.

 

Torque:
30 - 30,000 Nm
Outside diameter:
70 - 700 mm
Bore diameter:
12 - 220 mm
Length:
90 - 560 mm

Seperator